Description
Fissacril – Pre Primer for walls
FISSACRIL is a water-based fixative for interior and exterior use, formulated with acrylic emulsions.
This primer penetrates into the plaster and seals the porous surfaces by bonding unrelated parts of them.
It provides both a good vapour permeability and also an excellent adhesion for finish coatings
Making surface absorption is uniform, FISSACRIL allows colour uniformity throughout the application of paints/Venetian plasters
It is recommended for interior application on plasters and stucco and for exterior use on suitably prepared masonry walls and concrete, and newly fresh plaster
SURFACE PREPERATION
Interior new surfaces: All surfaces must be dry and cured according to the supplier’s recommendations – usually about 30 days.
Rough surfaces can be filled with putty FLYSTUK to provide a smooth surface; Ensure the support to be coated is clean with dust and dirt removed.
Apply one coat of primer FISSACRIL followed after 4/6 hours by two coats of wall paint.
For the application please refer to the technical methods given below.
Interior coated surfaces:
If you have any mildew this should be removed before painting by washing with a solution,
Mixed with 1 part liquid bleach and 3 parts water.
Apply the solution and scrub the mildewed area.
It requires the use of proper protective equipment. Existing peeled paint should be scraped and sanded to a sound surface.
Glossy surfaces should be sanded dull. Coatings in a poor condition should be removed completely.
Fill cracks and holes with putty FLYSTUK, once it is dry sand down to create a smooth surface.
Remove all sanding dust. Apply one coat of primer FISSACRIL followed after 4/6 hours by two coats of wall paint.
For the application please refer to the technical methods given below
Warning: Do not paint in direct sun or on a hot surface. Do not apply to wet surfaces.
Fissacril – Pre Primer for walls
PRODUCT APPLICATION
Brush: Use a nylon/polyester or a natural bristle brush. Roller: Use a nap synthetic or lamb’s wool roller cover.
Dilution depends on surface absorption. It ranges from 1:1 to 1:3 by volume with water.
Dilution depends on the airless system in use.
To make sure you have no problems in applying a trial application is strongly recommended prior to the commencement of work.
Warning: The addition of fixative to paints can not be considered as a substitute for the application of the fixative itself.
Only in the latter case, the fixative penetrates deep into the plaster and allows to standardize the absorption by sealing not consolidated parts of it.
The addition of fixative to paints, in fact, increases its resin content, but will not prevent such defects.
Temperature of application: +5 – +35ºC
Relative humidity of application: <85%
Touch dry: 30 MINUTES
Recoatable after: 4 -5 HOURS
Completely Cured: 7 DAYS
Cleaning tools: BY WATER
Coverage: 8-10 m2/L
Colour:clear
Gloss Levels: Translucent
If you are interested in learning more about our range of products we have available, why not attend one of our courses ?
We are based in Southport and offer 2 days to 5 day courses – Learn More
Reviews
There are no reviews yet.